| Share facebook | RSS

6
Comments

ambassador Report View

Nuclear Waste Management in India

by Sudarshan Sreeram | 26-05-2017 12:35 recommendations 0

Nuclear energy is generated when a nuclear fuel atom undergoes a reaction in which it splits into two smaller atoms. This generates heat which is then used in driving steam turbines to produce electricity. The leftover smaller atoms, known as fission products, constantly emit energetic particles which can cause biological damage. These fission products are the main key component of nuclear waste. So, in simple terms, nuclear waste is a toxic and hazardous material that nuclear fuel turns into after it is used inside a nuclear reactor. Furthermore, nuclear waste can exist in solid, liquid, and gas forms with varying levels of radioactivity.  

Nuclear energy is the fourth most used form of energy in India after thermal, hydroelectric, and solar. India has a total of 22 reactors in 8 nuclear plants. In addition, India has planned to add 6 more new plants to its inventory of nuclear power plants. The BARC or Bhabha Atomic Research Center is an organisation under the Government Of India Department Of Atomic Energy. This organisation acts as the mother of many research and development institutions that carry out research in nuclear technologies, nuclear power production, and materials technology. For the management of nuclear waste in India, a clear set of principles and standards are being followed in accordance with international guidelines.

Considering the safety of the environment, health of the human population, and protection of the future generations of India, the philosophy for the safe management of nuclear wastes in India is based on the concepts of "Delay and Decay", "Dilute and Disperse", and "Concentrate and Contain".  Depending on the level and nature of radioactivity, nuclear wastes can be divided into exempt waste, low and intermediate level waste, and high level waste (HLW). Effective management of nuclear waste involves a sequence of steps:
  • Segregation
  • Characterization
  • Handling
  • Treatment
  • Conditioning 
  • Monitoring prior to final disposal

Low and intermediate level wastes are relatively easy to dispose as their radioactivity levels are low. Storing them for about 10 to 50 years will allow the waste to decay, after which it is safe to dispose. On the other hand, high level wastes contain high radioactivity levels and hence should be isolated from a human populated environment. This type of waste should be handled with extreme care and always under constant surveillance. Management of HLW in India follows three steps:
  • Immobilization of high level liquid waste into vitrified boro-silicate glasses
  • Engineered interim storage of the vitrified waste for passive cooling & surveillance over a period of time, qualifying it for ultimate disposal
  • Ultimate storage/disposal of the vitrified waste in a deep geological repository.
The basic requirements for a deep geological repository are: remoteness from human population and ecological hot-spots, absence of circulating ground water, and ability to contain radionuclides (atoms which have excessive nuclear energy making it unstable) for long periods of time. Proper and safe disposal of nuclear waste is required for the preservation of environmental attributes such as soil, air, and water as well as the safety of humans.

If not handled with proper care and treatment, nuclear waste can pose as a clear threat to human life and nature. Nuclear waste can cause cancerous growths and genetic alterations which increases the difficulty of surviving. There have been many minor accidents at various nuclear power plants spread across India some of which are listed below.

Accidents at Indian Nuclear Power Plants:
  • In March 1993, two blades of the steam turbine in the Narora Atomic Power Station (NAPS) break off and cause a fire fueled by the leaking oil. This fire then spreads in the turbine building, but no alarms were activated as the smoke detectors failed to detect the fire. Later on, workers saw the fire spreading and there was a temporary blackout where power was not restored for seventeen hours.
  • In January 2003, a broken valve int the Kalpakkam Atomic Reprocessing Plant caused the release of high level waste exposing six workers to high doses of radiation. The plant had no radiation monitors or mechanisms to detect a valve failure which could have prevented the workers from being exposed to high levels of radiation.
  • In November 2009, five employees consumed radioactive material after the radioactive water (previously used for cooling the reactor) mixes with the drinking water cooler. The Nuclear Power Corporation Of India Ltd (NPCIL) reports the incident as "an insider's mischief".

Useful Links:
 
Nuclear Waste Management Process In India

no image

  • Dormant user Sudarshan Sreeram
 
 
  • recommend

6 Comments

  • says :
    thanks for sharing
    Posted 06-02-2018 21:46

  • says :
    good report
    Posted 06-02-2018 21:45

  • says :
    Hi Sudarshan, thanks for sharing your report on how nuclear wastes are managed in India.
    Thesedays, it is hard to find countries that haven't gone through any nuclear related incidents. I wonder what people think they should do about nuclear in India. Thanks for the report!
    Posted 01-06-2017 20:43

  • says :
    Sudarshan, thank you for your report. This was a good introduction to nuclear waste in India. Although India will follow international guidelines, adding 6 more new plants worries me. Aren??t there any significant disagree with adding new plants?
    Posted 29-05-2017 00:18

Aaditya Singh

  • Aaditya Singh says :
    Thanks Sudarshan for the informative Report. It is scary to read about the accidents at Indian Nuclear Plants. It is expected that the safety procedures and proper waste disposal are well taken care of of by suitable agencies.

    As for bullet points- I too face that problem- but sometimes. I am not sure what exactly causes it. I work in MS Word without bullets and insert the bullets in the Tunza Editor after pasting the text here.
    Posted 27-05-2017 21:40

  • Sudarshan Sreeram says :
    I don't know why, but bullet lists don't seem to appear in the final report (after posting). I write all my reports on Evernote, copy it on to the Tunza editor, and post it. In the final version of the report, I see the contents of the list, but I don't see the 'dot' (bullet). Is anyone else facing the same problem? Thanks!
    Posted 26-05-2017 12:50

Post a comment

Please sign in

Opportunities

Resources